Filter
Top Products
Quick Guide to Your TV
Startup
2
2. Plug in the TV
Hook up your antenna or cable to
the TV before you follow the steps
below.
The steps below will get your TV connected and ready for watching.
For more details, see the page numbers listed.
3. Put Batteries in the Remote
A. Pull off the cover of the battery
compartment.
B. Place the two AAA batteries as
shown, matching the + and –
end of each battery in the
compartment.
C. Replace the cover.
OR OR
OR
CABLE /
ANTENNA
Back of TV
Adapters
VHF & UHF VHF & UHF VHF UHF VHF UHF
Match Your Type of Antenna or Cable
Plug the cord into the outlet,
matching the wide and the small
end of the plug with the outlet.
1. Hook up your TV
It is important to use only
the adapters specified as
they incorporate special
isolation circuitry to meet
safety regulations.
CAUTION: If you choose to use a stand with your TV, take precautions that the stand or furniture the TV is
placed on is properly located and of adequate size and strength to prevent the TV from accidentally being
tipped over or pulled off. This could cause damage to the TV and or personal injury.