Filter
Top Products
11
9. The Autosearch sends the next code
in the list every three seconds.
Note: The Autosearch can take a
significant amount of time, since
there are many codes in the list.
10.To speed up the Autosearch, you can
manually override the process and
temporarily speed it up by pressing
the normal search keys (CH
+
, CH
-
,
ON•OFF, PLAY, LCD UP, and LCD
DOWN keys) in both forward and
reverse directions.
11. If your device responds to the command,
and the RCU 900 sends the next code
before you have a chance to press the
LCD OK key, you can backtrack
through the code library by pressing
CH
-
or the DOWN ARROW. You can
change the direction to forward once
again by pressing the ON/OFF, CH
+
,
LCD UP ARROW, or PLAY keys.
12. Once the device to be controlled responds
to the commands, press and release the
LCD OK key to install the code.
13.The touchscreen returns to the Main
Setup Screen. The Code Search entry
is now complete.
14.Press CLEAR on the Main Setup
Screen to exit Setup Mode.
Code Identification
Code Identification allows you to find out what codes are
programmed in the remote under a given mode (TV, VCR, DVD, etc.).
To find out the currently programmed code, follow these steps:
1. Press and hold the SETUP key on
the rubber keypad until the LED
indicator light remains on and the
touchscreen shows the Main Setup
Screen. This process takes
approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and release the LCD CODE
key. The LED indicator light blinks
once to indicate acceptance of
the keypress.
4. The touchscreen now shows Device
Setup Screen. Press and release the
device key on the rubber keypad for
the device whose code you want to
identify (TV, VCR, SAT/CBL, etc.).
The LED indicator light blinks
once to indicate acceptance of
the keypress.
5. The touchscreen now shows the
Code Setup Screen. Press and release
the SETUP key. The LED indicator
light blinks once to indicate
acceptance of the keypress.
6. The touchscreen now shows the
Code ID Setup Screen (initially blank
except for LCD SETUP, INFO and
CODE keys). The touchscreen then
shows the code, using the LCD
digits. The digits in the three-digit
code are shown in sequence for
RCU900_IB_revC.qxp 12/3/02 9:45 Page 11