Filter
Top Products
9
DVD Codes
Programming For DVD
1. Manually turn on the DVD System.
Find the three digit code for your DVD
System in the code list below.
2. Press and hold the CODE SEARCH
button until the INDICATOR LIGHT
lights, then release the CODE SEARCH
button.
3. Press and release the DVD button
(The INDICATOR LIGHT will blink
then remain lit).
4. Enter the code using the Number
Buttons.
After your code is entered, the
INDICATOR LIGHT will turn off. If
the code is not valid, the INDICATOR
LIGHT will blink. Check the code list
and repeat process.
5. Aim the remote at your DVD System
and press the ON•OFF button. Your
DVD System should turn off.
6. If the DVD System responds, no further
programming is required.
Note: If your DVD does not respond, try all the
codes for your brand. If the codes do not work,
or your brand is not listed, try the Code Search
method on page 16.
7. Enter your code here for easy reference.
Most RCA, GE and ProScan DVD systems will not require
programming. Check to see if your DVD System responds
to the remote before you begin programming.
(OFF)
DVD CODE
(BLINK)
INDICATOR
LIGHT
ON OFF
DVD
CODE
SEARCH
Aiwa ........................................350
Hitachi......................................351
JVC....................................161, 352
Konka ..............................353, 354
Magnavox................162, 356, 357
Mitsubishi................................163
Panasonic ................................355
Philips ......................162, 356, 357
Pioneer......................................165
ProScan ....................................160
RCA ..........................................160
Sanyo........................................359
Sony..........................166, 360, 361
Toshiba ....................167, 362, 363
Zenith ......................................364
10
Satellite Codes
Programming For DBS System
1. Manually turn on DBS System.
Find the three digit code for your DBS
System in the code list below.
2. Press and hold the CODE SEARCH
button until the INDICATOR LIGHT
lights, then release the CODE
SEARCH button.
3. Press and release the DBS•SAT button
(The INDICATOR LIGHT will blink then
remain lit).
4. Enter the code using the Number
Buttons.
After your code is entered, the
INDICATOR LIGHT will turn off. If
the code is not valid, the INDICATOR
LIGHT will blink. Check the code list
and repeat process.
5. Aim the remote at your DBS System
and press the ON•OFF button. Your
DBS System should turn off.
Note: If your DBS System does not respond,
try all the codes for your brand. If the codes do
not work, or your brand is not listed, try the
Code Search method on page 16.
6. With your DBS System on, press CH+
(CHANNEL UP). If the satellite system
responds, no further programming is
required.
7. Enter your code here for easy reference.
Most RCA, GE and ProScan Satellite systems will not require
programming. Check to see if your DBS Satellite System
responds to the remote before you begin programming.
(OFF)
SATELLITE CODE
(BLINK)
INDICATOR
LIGHT
ON OFF
Alphastar..................................079
Echostar (Dish System)..........089
Echosphere (Dish Net) ..........079
GE..............................071, 080, 081
Hitachi SYS I............................084
Hitachi SYS II ..........................083
Hughes ............................077, 090
Magnavox ................................085
JVC............................................082
Panasonic ................................075
Philips ......................................085
Primestar..................................076
Proscan ....................071, 080, 081
RCA ..........................071, 080, 081
Sony ..........................................072
Toshiba......................................073
Uniden......................................086
DBS•SAT
CODE
SEARCH
RCU600RS manual 4/11/01 12:15 PM Page 10