RCA RCU403 Universal Remote User Manual


 
4
Other Keys (listed alphabetically)
0-9 (Number Keys): operate the same as number keys on your
original remote and are used to enter component codes when
programming the remote control with Direct Entry method.
ANTENNA: in TV mode, switches between the signal coming
from a satellite receiver or cable box and an off-air antenna.
In VCR mode, switches between the signal coming from a
VCR and a TV.
CHAN (Channel) UP AND DOWN: goes to the next highest
or lowest channel number in the component channel list,
respectively, except for DVDs. In DVDs the CHAN UP/DOWN
goes to the NEXT/PREVIOUS chapter. Additionally, when
you’re using the remote with On-screen Menus, the CHAN
keys act as UP ARROW and DOWN ARROW keys (moving
the cursor or highlight up or down).
CODE SEARCH: use to program the remote.
ENTER: use with Manual or Automatic Code Search method
to accept code (See Code Search on page 8). Also, some
brands require you to press the ENTER key after you enter
a channel number. In some menu systems, you must press
ENTER to select a highlighted item.
MENU: accesses DVD disc menus when VCR•DVD key
is programmed to operate a DVD player. Accesses menu
systems of some TVs, a few RCA brand VCRs and satellite
receivers. (For more information, refer to Using On-screen
Menus section on page 10).
MUTE: lowers the TV’s volume to its minimum level.
ON•OFF: turns component on and off.
Note: Some RCA, GE and PROSCAN models require that
you press the component key to turn ON the component
and the ON•OFF key to turn OFF the component.
PREV CH (Previous Channel): switches back to previous
channel—operates the same as LAST CHANNEL, GO BACK
or RECALL key found on some brands of remote controls.
REC (Record): used with VCR to record programming.
You must press the REC key twice
to start recording.
VOL (Volume) UP and DOWN: increases or decreases the
TV’s volume level. Additionally, when you’re using the remote
with On-screen Menus, the VOL keys act as RIGHT or LEFT
ARROW keys (moving the highlight or cursor right or left).
RCU403_US_IB_REVB 4/10/03 16:47 Page 4