Filter
Top Products
3
6. Wrap each lead of the twin-lead cable around one of the
VHF antenna’s lead-in terminals (on both sides of the
boom).
7. Replace the spade terminals (if removed in Step 5), flat
washers, and large wing nuts.
Note: In some locations, you might need to use an indoor/out-
door 300-ohm splitter/combiner (available at your local Ra-
dioShack store) to receive a satisfactory picture on your TV.
ROUTING THE CABLE TO YOUR TV/VCR
If you use coaxial cable:
• Use plastic tape or mast standoff insulators to secure the
coaxial cable to the mast at about 3-foot intervals. Continue
down the roof and the side of the house using roof and wall
standoff insulators.
• Use coaxial cable nail-in clips every few feet to secure the
cable between the mast and where the cable enters the
house.
• Use a 75-ohm grounding block at the point where the coax-
ial cable enters the house. Read the Consumer Product
Safety Commission sheet for grounding instructions.
• Use a wall-through lead-in tube (not supplied) to neatly
route the coaxial cable through walls.
If you use twin-lead cable:
• Be sure the twin-lead cable remains at least 4 inches away
from all metal surfaces.
• Use standoff insulators about every 4 feet. Twist the twin-
lead cable about three turns between standoff insulators.
• Read the separate Consumer Product Safety Commission
sheet for grounding instructions.
CONNECTING TO YOUR TV/VCR
Connect the antenna’s lead-in cable to your TV/VCR’s antenna terminals according to the type of cable you used. RadioShack car-
ries a variety of matching transformers, if one of these suits your needs. Below are some sample connections.
Make connections as described if you have:
• Coaxial antenna lead-in
• Twin-lead TV/VCR antenna terminals
Make connections as described if you have:
• Coaxial antenna lead-in
• Coaxial TV/VCR antenna terminal
Large Wing
Nuts
Flat Washers
VHF Antenna’s
Lead-In Terminal
Twin-Lead Cable
to UHF Antenna
RadioShack
Indoor/Outdoor
Matching Transformer
Cat. No. 15-1140
Connect to TV/VCR’s
300-Ohm Screw Terminals
Connect
Coaxial Lead-In
from Antenna
Connect to TV/VCR’s
75-Ohm F-Connector
Coaxial Lead-In
from Antenna
15-2160.fm Page 3 Friday, April 28, 2000 5:47 PM