RocketFish RF-TVMLPT01 TV Video Accessories User Manual


  Open as PDF
of 2
 
Tools you will need:
• Stud nder
• Awl
• Level
• Pencil
Package contents
A TV bracket (1)
B Wall plate (1)
M4 bag
C M4 x 12 mm screws (4)
D M4 x 30 mm screws (4)
E M4 washers (4)
F M4 spacers (4)
Miscellaneous bag
G Locking screw (1)
H 5/32 in. hex key (1)
Lag bolt bag
I 5/16 in. x 2¾ in. lag bolts (2)
J Concrete anchors (2)
Thank you for choosing the
Rocketsh RF-TVMLPT01.
The RF-TVMLPT01 TV mount
is designed to support
a TV weighing up to
50 lbs. (22.7 kg).
• Hammer (Concrete Only)
• Tape measure
• Power drill
• 3/16 in. wood drill bit
• 3/8 in. masonry
drill bit(Concrete Only)
• Socket wrench with ½ in. socket
or adjustable wrench
• Phillips screwdriver
QUICK SETUP GUIDE
RF-TVMLPT01
M4 x 12mm
in.
M4 bag
Miscellaneous bag
Lag bolt bag
A
B
C
D
G
H
I
J
1 Install locking screw
Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H).
Do not screw in more than three or four turns.
2 Attach the TV bracket
Option 1: If the back of the TV is at
Align the TV bracket (A) with the mounting screw holes
on the back of the TV. Place the washers (E) over
the screw holes on the TV bracket.
Note: If the hole pattern on your TV is 75 mm x 75 mm,
do not use the washers. Insert the screws (C) though
the screw holes and tighten.
G
H
A
E
C
With washers
M4 x 30mm
E
F
M4
M4
A
C
Without washers
Option 2: If the back of the TV is curved or to make room for cables
Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D).
Note: If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used.
A
E
F
D
A
D
F
With washers
Without washers