Filter
Top Products
INTRODUCTION
Thank you for your purchase of the Rolls CS1000 Cable Scanner. In addition to testing
ten different cable ends, it has a variable level 1 kHz Tone Generator for testing audio
equipment, and a Phantom Power voltage and phase tester. This device was designed
with the audio professional in mind. Please take a moment and review this manual as it
contains important information for proper operation of the CS1000.
PLEASE NOTE: This Owners Manual assumes the user
has a basic working knowledge of audio equipment and
connectors.
To prolong battery life, remember to move the TEST
TONE / CABLE TEST switch to the OFF position when
the CS1000 is not in use
INSPECTION _____________________________________________________
1. Unpack and inspect the CS1000 box and package.
If obvious physical damage is noticed, contact the carrier immediately to make a
damage claim. We suggest saving the shipping carton and packing materials for
safely transporting the unit in the future.
2. Please complete our online Warranty Registration by visiting our website;
www.rolls.com. Click on the REGISTER YOUR WARRANTY HERE line. Or,
complete the Warranty Registration Card and return it to the factory.
TABLE OF CONTENTS ____________________________________________
Introduction 1
Inspection 1
Table of Contents 1
Battery Installation 1
Description 2
Section I: Cable Scanning 3
Section II: 1 kHz Test Tone 4
Section III: Phantom Power 4
Schematic 5
Typical Cable Scan Chart 5
Specifications 6
Warranty Back Cover
BATTERY INSTALLATION __________________________________________
The CS1000 operates on a single 9 volt alkaline battery. To replace the battery,
press in the small tab on the side of the battery cover and lift it up. Carefully
remove the battery from the CS1000 and disconnect the battery cable. Connect a
new 9 volt alkaline to the battery cable and place into the compartment. Replace
the battery cover. Remember to properly dispose of the old battery.
SPECIFICATIONS
Scan rate: 300mS per LED
Test Tone frequency: 1 kHz
Test Tone level: -30 dB to + 7 dB balanced
Tone output impedance; 100 Ohms unbalanced
200 Ohms balanced
No. of LEDs: 17
Estimated battery life: 6 hours of operation
Size: 4.65” W x 6.95” H x 2.275” D
(11.8 x 17.65 x 5.78 cm)
Weight (with battery): 2.8 lbs.
_________________________________________________________________
TYPICAL CABLE SCAN CHART
CABLE JACKS LEDS
---------------------------------------------------------------------------------------
SEND RECEIVE SEND RECEIVE
Speaker 1/4” Banana 1 1
22
31
Speaker 1/4” Speak-on®111
22
31
Instrument 1/4’ 1/4’ 1 1,3
22
3 1,3
Microphone XLRf XLRm 1 1
22
33
Stereo Sound Card 1/8” 1/8” 1 1
22
33
MIDI (5 pin) MIDI MIDI 1 1
22
33
44
55
Telephone RJ11 RJ11 2 5
34
43
52
1
6
Speak-On® is a registered
trademark of Neutrik
Note: This will vary greatly depending
on the number of wires connected and
what type of telephone the cable is for.
The chart is for a standard phone line
to telephone cable.