Filter
Top Products
Installation
24 Runco LS-HB/LS-HB Ultra Installation/Operation Manual
PRE
L
IMINAR
Y
3.5
Installing the Optional
Anamorphic Lens
Mount
If you are installing a standard LS-HB (without an anamorphic lens), skip this step and
proceed with Mounting the LS-HB (page 30).
If you are installing an LS-HB with a fixed anamorphic lens, proceed with
Installing the Fixed Anamorphic Lens Base Plate (page 29).
If you are installing an LS-HB with a movable anamorphic lens, proceed
as follows to install the lens mount and transport assembly.
Installing the Movable
Anamorphic Lens
Transport Assembly
Package Contents: The LS-HB movable anamorphic lens mount kit consists of the
following items. Some components shipped with your projector may differ slightly from
what is shown in these instructions. If any items are missing or damaged, please contact
your Runco dealer or Runco Customer Service at (800) 23RUNCO.
• Transport Assembly Attachment Plate
• Attachment plate hardware (screws,
washers and spacers)
• Attachment plate security hooks and
related hardware (chain, chain ends,
nuts and washers)
• Transport Assembly
• Transport mounting hardware
• Lens bracket mounting hardware
• Power supply
• Remote control unit and batteries
1. Do not install the anamorphic lens yet, only the transport
assembly and/or lens mount. You will install the anamorphic lens
after you install the projector and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
Note
➤