Filter
Top Products
Controls and Functions
Runco PlasmaWall Owner’s Operating Manual 7
PRE
L
IMINAR
Y
1. POWER INPUT (100 to 240 VAC)
Connect the PlasmaWall to power here, using the included power cord.
2. EXTERNAL SPEAKER OUTPUTS
Not used. Connect speakers to an external audio amplifier/receiver.
3. VIDEO1, VIDEO2, VIDEO3 (BNC, RCA, S-Video)
Not used. Connect all video sources to the DHD Controller.
4. AUDIO1, AUDIO2, AUDIO3
Not used with this model. Connect the audio outputs from your sources to an external
audio receiver.
5. COMPONENT1
Not used. Connect all video sources to the DHD Controller.
6. PC2/COMPONENT2 (5xBNC)
Connect the RGBHV (5xBNC) output from the DHD Controller here.
7. PC1 (15-pin D-Sub)
Not used. Connect all video sources to the DHD Controller.
8. PC3 (DVI)
HDCP-compliant digital video input. Connect the DVI output from the DHD
Controller to this input.
9. RS-232C (9-pin, male D-Sub)
A male, 9-pin D-sub connector. Connect the RS-232 OUT port on the DHD
Controller to this input.
10. REMOTE IN (3.5-mm mini phone jack, tip/ring/sleeve)
Wired input (3.0 VDC/300 mA) from an external remote control or infrared (IR)
receiver.
11. REMOTE OUT (3.5-mm mini phone jack, tip/ring/sleeve)
Wired output to the REMOTE IN jack of another device; allows you to control both the
PlasmaWall and the other device using the same wired remote control.