Filter
Top Products
Installation
24 PlasmaWall SP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Digital Video Connection: The PlasmaWall has a DVI input, labeled DIGITAL RGB.
Connect the DVI output from the DHD Controller to this input, using a standard DVI cable.
RGBHV Connection: Connect the RGBHV output from the DHD Controller to the
ANALOG RGB IN input on the PlasmaWall. Use a standard, RGBHV breakout cable with
five BNCs at the DHD end and a 15-pin, D-sub male connector at the PlasmaWall end.
RS-232 Connection: Connect the RS-232 output from the DHD Controller to the
RS-232C input on the PlasmaWall. Use a standard, modular telephone cable with RJ11
plugs at both ends. On the PlasmaWall end, use the provided RJ11-to-DB9 adapter. This
adapter is wired as shown in
Figure 3-4.
Figure 3-4. RS-232 Connection from the DHD Controller to the PlasmaWall
3
4
2, 5
XMT DATA
RCV DATA
REQUEST TO SEND
SIG GND
3
2
8
7
5
RCV DATA
XMT DATA
CLEAR TO SEND
NO CONNECTION
1, 6
1, 9
SIG GND
To/From
DHD
Controller
PlasmaWall
RJ-11 Male
DB-9 Female
1 5
6 9
RS-232C