Samsung 1357B-BD-P1200-XAC Blu-ray Player User Manual


 
English - 19
Connecting
Depending on the manufacturer, the
component terminals on your TV may be
marked R-Y, B-Y, Yor Cr, Cb, Yinstead of
PR, PB, Y. The number and position of
terminals may vary depending on the TV set.
Please refer to the user's manual of your TV.
NOTE
Connecting to a TV (Component)
- Connecting to your TV using Component video cables.
- You will enjoy high quality and accurate color
reproduction images. Component video separates the
picture element into black and white(Y), blue(PB),
red(PR) signals to present clear and clean images.
(Audio signals are delivered through the audio output.)
1. Using component video cables (not included),
connect the COMPONENT VIDEO OUT terminals on
the rear of the Blu-ray disc player to the
COMPONENT IN terminals of your TV.
2. Using the audio cables (not included), connect the
AUDIO (red and white) OUT terminals on the rear of
the Blu-ray disc player to the AUDIO (red and white)
IN terminals of your TV. Turn on the Blu-ray disc
player and TV.
3. Press the OUTPUT SELECT button on the front
panel of the unit until the COMP indicator lights.
Make sure the unit is in Stop mode.
4. Press the input selector on your TV remote control
until the Component signal from the Blu-ray disc
player appears on the TV screen.
If you have set the remote control to properly operate
with your TV (pages 14~15), press the TV INPUT SEL.
button on the remote control and select COMPONENT
as the external source of the TV.
LAN
RED
WHITE
RED
WHITE
RED
BLUE
GREEN
RED
BLUE
GREEN
Audio Cable
Component cable
(not included)
Connecting to a TV (S-Video)
- Connecting to your TV using an S-Video cable.
- You will enjoy high quality images. S-Video separates
the picture element into black and white(Y) and
color(C) signals to present clearer images than regular
video input mode.
(Audio signals are delivered through the audio output.)
1. Using an S-Video cable (not included), connect the
S-VIDEO OUT terminal on the rear of the Blu-ray disc
player to the S-VIDEO IN terminal of your TV.
2. Using the audio cables, connect the AUDIO (red and
white) OUT terminals on the rear of the Blu-ray disc
player to the AUDIO (red and white) IN terminals of
your TV. Turn on the Blu-ray disc player and TV.
3. Press the OUTPUT SELECT button on the front
panel of the unit until the VIDEO indicator lights.
Make sure the unit is in Stop mode.
4. Press the input selector on your TV remote control
until the S-Video signal from the Blu-ray disc player
appears on your TV screen.
If you have set the remote control to properly operate
with your TV (pages 14~15), press the TV INPUT SEL.
button on the remote control and select S-VIDEO as
the external source of the TV.
LAN
RED
WHITE
RED
WHITE
Audio Cable
S-Video Cable
(not included)
P1200_XAC_ENG_1~36 3/7/70 11:13 AM Page 19