To register this product please visit
www.samsung.com/register.
Quick Setup Guide
BN68-02879E-X0
Wall Mount Kit Specications (VESA)
Install your wall mount on a solid wall perpendicular to the oor. When attaching
to other building materials, please contact your nearest dealer. If installed on a
ceiling or slanted wall, it may fall and result in severe personal injury.
➣ Standard dimensions for wall mount kits are shown in the table below.
➣ When purchasing our wall mount kit, a detailed installation manual and all
parts necessary for assembly are provided.
➣ Do not use screws that do not comply with the VESA standard screw
specications.
➣ Do not use screws that are longer than the standard dimension or do not
comply with the VESA standard screw specications. Screws that are too
long may cause damage to the inside of the TV set.
➣ For wall mounts that do not comply with the VESA standard screw
specications, the length of the screws may differ depending on the wall
mount specications.
➣ Do not fasten the screws too strongly; this may damage the product or
cause the product to fall, leading to personal injury. Samsung is not liable
for these kinds of accidents.
➣ Samsung is not liable for product damage or personal injury when a non-
VESA or non-specied wall mount is used or the consumer fails to follow
the product installation instructions.
➣ Our 57” and 63” models do not comply with VESA Specications. Therefore,
you should use our dedicated wall mount kit for this model.
➣ Do not mount the TV at more than a 15 degree tilt.
➣ Always use two people to mount the TV to a wall.
Product
Family
inches
VESA Spec.
(A * B)
Standard
Screw
Quantity
LED TV
[Ultra-Slim]
19 ~ 22 75 X 75
M4
4
23 ~ 29
200 X 100
M8
32~37 200 X 200
40~55
400 X 400
56~65
600 X 400
Do not install your Wall Mount Kit while your TV is turned on.
It may result in personal injury due to electric shock.
Viewing the Connection Panel
Installing the LED TV Stand
See separate guide for installing the stand.
s
s
s
s
s
(A)
(B)
5EA (M4 X L12)
5EA (M4 X L8)
Stand (1EA) Guide Stand (1EA) Screws (10EA)
Follow the steps below to connect the TV to the stand.
s
s
s
s
s
1
s
s
s
s
s
2
1. Connect the Guide Stand
to the Stand using four
screws (M4 X L12) as
shown.
2. With your TV upright,
connect the TV to the
Stand as shown.
3. Fasten two screws (M4
X L8) at position
1
, and
then fasten three screws
(M4 X L8) at position
2
.
✎
NOTE
x
Make sure to distinguish between the front and back of the Stand and Guide
Stand when assembling them.
x
Make sure that at least two persons lift and move the LED TV.
x
Stand the product up and fasten the screws. If you fasten the screws with the
LED TV placed down, it may lean to one side.
s
s
s
s
s
Top view
Rear
Guide Stand
Screws (M4 X L12)
Stand
Installing the Wall Mount Kit
Wall mount items (sold
separately) allow you to mount
the TV on a wall. For detailed
information on installing the
wall mount, see the instructions
provided with the Wall Mount
items. Contact a technician for
assistance when installing the
wall mounted bracket. Samsung Electronics is not responsible for any damage
to the product or injury to yourself or others if you select to install the TV on your
own.
➣ Remove the stand and cover the bottom hole with the cover.
Blanking Bracket
List of Parts
1
Remote Control & Batteries (AAA x 2)
2
Power Cord
3
Cleaning Cloth
4
Blanking Bracket
5
Data Cable (BN39-00865B, BN39-01011B)
6
Stand & Screw (M4xL16)
7
Warranty Card / Safety Guide (Not available in some locations)
1
5 6 7
2 3 4
(M4xL8)
EU Hotel (4000)
1
2
3
4
5
467890!@
1
2
$
%
4
5
46780!@
1
2
$
#
%
4
5
46770 8!@
9
Power Input
Mideast Africa Hotel (4000)
1
2
3
4
5
467890!@
1
2
$
%
4
5
46780!@
1
2
$
#
%
4
5
46770 8!@
9
Power Input
Aus, NZ, Singapore Hotel (4000)
1
2
3
4
5
467890!@
1
2
$
%
4
5
46780!@
1
2
$
#
%
4
5
46770 8!@
9
Power Input
1 RJP
2 USB (HDD) / CLONING
3 COMMON INTERFACE
4 HDMI IN 1(DVI), 2
5 PC / DVI AUDIO IN
6 PC IN
7 COMPONENT IN
8 AV IN
9 EXT(RGB)
0 ANT IN
! DATA
- Used to support data communication between the TV and the SBB.
@ Power input
# AV OUT
- AUDIO OUT
- VIDEO OUT
(DTV signal is unsupportable. This output is only for Analogue video signal.)
$ Headphones jack
% HP-ID
1
Holder-Wire Stand
2
Cable Tie
3
Holder-Wire (3EA)
4
Holder-Ring (4EA)
5
Power Cord Clamp
6
Component Adapter
7
AV Adapter
(Aus, Singapore, NZ only)
8
Audio Adapter
(Aus, Singapore, NZ only)
9
AV Adapter
0
SCART Adapter
(EU, Mideast Africa only)
1
2
3
4
5
6
7 8 9 0
[QSG]BN68-02879E-Hotel.indd 1 2010-04-13 오전 10:04:33