Filter
Top Products
English - 4
Setup - Time
Clock
Setting the clock is
necessary in order to use
the various timer features of
the TV. Also, you can check
the time while watching the
TV. (Just press the INFO
button.)
On Timer / Off Timer
You can set the On/Off timers so that the TV will switch on
or off automatically at the time you select.
➢
You must set the clock first.
Sleep Timer
You can select a time period of between 30 and 180
minutes after which the TV automatically switches to
standby mode.
➢
Press the SLEEP button on the remote control
repeatedly until the appropriate time interval appears
(any of the preset values from “30 Min.” to “180 Min.”).
On Timer Volume
The preferred volume can be set for when the timer
automatically turns on the TV.
☛
Auto Power Off
When you set the timer “On”, the TV will eventually turn
off, if no controls are operated for 3 hours after the TV was
turned on by timer. This function is only available in timer
“On” mode and prevents overheating or leakages, which
may occur if a TV is on for too long.
Channel - Name
Use this feature to assign an
easy-to-remember label to any
channel (i.e., “CBS”, “ESPN”,
“PBS2”, “CNN1”, etc.).
A label consists of four fields,
where each field is a letter
(A~Z), a number (0~9), a blank,
or -. When the INFO button is
pressed, the channel label will
appear next to the channel number.
➢
You cannot select “Name” in the AV mode.
Channel - Memorizing the Channels
Your TV can memorize and store all of the available channels
for both air and cable channels. After the available channels
are memorized, use the CH and CH buttons to scan
through the channels.
This eliminates the need to change channels by entering the
channel digits. There are three steps for memorizing channels:
“Air/CATV”, “Auto Program” and “Add/Delete”.
Air/CATV
Before your TV can begin
memorizing the available
channels, you must specify
the type of signal source
that is connected to the TV
(i.e., an antenna or a cable
system). Select “Air”, “STD”,
“HRC”, or “IRC” by pressing the ◄ or ► button.
Auto Program
All available channels are
automatically stored in
memory when channels are
selected by the direct tuning
function.
Press the ENTER button
at any time to interrupt the
memorization process.
Add/Delete
You can add or delete
a channel to display the
channels you want only.
To use the “Add/Delete”
function, first run Auto
Program.
Select “Deleted” or “Added”
by pressing the ▲ or ▼ button.
Move Adjust Skip
Channel
Auto Program ►
Add/Delete : Deleted ►
Air/CATV : Air
Name :
----
Auto Program
Enter Return
Start
Air 7
Move
Enter Return
Channel
Auto Program ►
Add/Delete : Deleted
Air/CATV :Air
Name :
----
Deleted
Added
Move Adjust Return
Channel
Auto Program ►
Add/Delete : Deleted ►
Air/CATV : Air
Name :
----
A
Move Adjust Return
Time
Clock 12 : 00 am
On Timer
-- : -- am Off
Off Timer
-- : -- am Off
Sleep Timer : Off
On Timer Volume : 10
AA68-03806S_00Eng_0110.indd 4 2008-01-10 ¿ÀÈÄ 4:31:05