Filter
Top Products
11
Connecting VHF and UHF Antennas
If your antenna has a set of leads that
look like this, see “Antennas with
300-ohm Flat Twin Leads,” below.
If your antenna has one lead that looks
like this, see “Antennas with 75-ohm
Round Leads,” on page 12.
If you have two antennas, see “Separate
VHF and UHF Antennas,” on page 12.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
Chapter Two
INSTALLATION
1
Place the wires from the
twin leads under the
screws on the 300-75 ohm
adaptor (not supplied).
Use a screwdriver to
tighten the screws.
INPUT
OUTPUT
VIDEO AUDIO
75
V
E
2
Plug the adaptor into the
VHF/UHF terminal on the
bottom of the back panel.
2
02825A(E)-CHAPTER 2 6/16/03 4:06 PM Page 11