Filter
Top Products
51
Special Features
50
Setting Up the Remote to Operate Your DVD
1
Turn off your DVD.
2
Press the MODE button and make sure
that the DVD LED is illuminated.
3
Press the SET button on your TV’s remote
control.
4
Using the number buttons on your
remote control, enter three digits of the
DVD code listed on page 51 of this
manual for your brand of DVD. Make
sure you enter three digits of the code,
even if the first digit is a “0.” If there is
more than one code listed, try the first
one.
5
Press the Power button on the remote
control. Your DVD should turn on if your
remote is set up correctly.
If your DVD does not turn on after set
up, repeat steps 2, 3, and 4, but try
one of the other codes listed for your
brand of DVD. If no other codes are list-
ed, try each code, 000 through 008.
Note on Using Remote Control Modes: DVD
• When your remote control is in “DVD” mode, the volume buttons still control your TV’s volume.
Remote Control Codes
VCR Codes
Cable Box Codes
DVD Codes
BP68-00142A-4 5/27/03 10:08 AM Page 50
Downloaded from www.Manualslib.com manuals search engine