Filter
Top Products
38
Storing Channels in Memory
4
Select the correct signal source (STD, HRC, and
IRC) by pressing the ▲ or ▼ button, then press
the ENTER button
.
Note
•
STD, HRC, and IRC identify various types of cable
TV systems. Contact your local cable company to
identify the type of cable system that exists in your
particular area. At this point the signal source has
been selected.
5
The TV begins memorizing all available stations.
Press the ENTER button at any time to interrupt the
memorization process.
Press the EXIT button to exit.
Note
•
The TV must be connected to an antenna in
order to receive digital TV signals.
Even if a particular channel is deleted from the
memory, you can always tune to that channel
directly by using the number buttons on the
remote control.
Notes
• All available DTV and analog channels are automatically stored in memory when channels are
selected by directly accessing channels.
• It takes approximately 3 to 10 minutes to memorize channels.
Auto Program
Enter Return
Auto Program in Progress.
Cable Channel 67
Stop
Select the cable system.
STD
HRC
IRC
Auto Program
TV
Move Enter
Return
BN68-00835N-00Eng_(032~045) 5/25/05 11:27 AM Page 38