Filter
Top Products
English-47
Power Saver
This set has a built-in power management system called PowerSaver. This system saves energy by
switching your set into a low-power mode when it has not been used for a certain period of time.
The available modes are “On”, “Standby”, “Sleep”, and “Deep Sleep”. PowerSaver operates with a VESA
DPMS compliant video card installed in your computer. You use a software utility installed on your
computer to set up this feature.
State Normal Operation
Power-Saving Function mode
(EPA/NUTEK)
Horizontal Sync Active Inactive
Vertical Sync Active Inactive
Power Indicator Off Red, Blinking (1 sec interval)
Power Consumption 15” 40W, 20” 55W Less than 3W
➣
This set automatically returns to normal operation when horizontal and vertical sync
are restored.
This occurs when you move the computer’s mouse or press any key on the keyboard.
Troubleshooting: Before Contacting Service Personnel
In PC mode, the image is not stable and
may appear to vibrate.
In PC mode, the image is not centred on
the screen.
◆ Check that the display resolution and frequency from your
computer or video board is an available mode for your set.
On your computer check: Control Panel, Display, Settings.
◆ If the setting is not correct, use your computer utility programme to
change the display settings.
◆ Adjust the horizontal and vertical position.
Your set supports multiscan display functions within the
following frequency domain:
Horizontal frequency(kHz)
Vertical frequency(Hz)
Maximum refresh rate
(at 75Hz)
TFT LCD panel manufactured by using advanced semiconductor technology with precision of 1ppm(one millionth)
above is used for this product. This is not from bad quality and you can use it without uneasiness.
For example, the number of TFT LCD sub pixels: LE15S51B - 2,359,296, LE20S51B - 1,921,600
15”(LE15S51B)
30~69
50~75
1024x768
20”(LE20S51B)
28~33
50~70
640x480
04-BN68-00816D-00Eng.qxd 2/17/05 9:36 PM Page 47