Filter
Top Products
English-64
Operating the DTV Menu
1.3 Manual Scanning
• Select the Channel Number.
You can select the specified channel you want to find.
The followings are defined as a default, but optionally you can
choose it. Signal Status bar shows you if it is valid.
• Input the frequency of the channel you want to find.
• Select the bandwidth. You can select the value of 6, 7 or 8 MHz.
• Select the Guard Interval Mode.
You can select the value of AUTO, 1/32, 1/16, 1/8, or 1/4.
• Select the FFT (Fast Fourier Transform) Mode.
One of the values-AUTO, 2K, and 8K- will be selected automatically.
You may change the set value as your preference.
• After select option, press the
ENTER/OK
button to start the
scanning process.
To tune-in new channels and weak signals, the TV has been
provided with the option “Manual Scanning” where the channel
data can be entered by the user.
After selecting the “Manual Scanning” from the Installation Menu,
the following screen will be displayed:
1.4 Reset to Factory Defaults
This is to restore the factory set values in case the user has
encountered some problems after changing any values of channel
data and others which may be in error.
At the request window, if you press the ENTER/OK button, the TV
will be reset to factory default settings automatically.
This causes your previous settings to be deleted!
2. Channel Organising
• Enter the PIN Code.
If you have not entered your own PIN Code 0000 applies, which was
set at the factory.
The “Channel Organising” menu has four functions:
The “Channel Organising” menu is used to delete the
Frequencies and Channels or move&edit channel as you want.
Once you have entered PIN Code, you do not have to input the code
again unless you turn the TV power off.
02 BN68-00953A-00Eng.qxd 9/28/05 11:26 AM Page 64