Filter
Top Products
English-39
Power Saver
This set has a built-in power management system called PowerSaver. This system saves energy by
switching your set into a low-power mode when it has not been used for a certain period of time.
The available modes are “On”, “Standby”, “Sleep”, and “Deep Sleep”. PowerSaver operates with a
VESA DPMS compliant video card installed in your computer. You use a software utility installed on
your computer to set up this feature.
State Normal Operation
Power-Saving Function mode
(EPA/NUTEK)
Horizontal Sync Active Inactive
Vertical Sync Active Inactive
Power Indicator Green Green, Blinking (1 sec interval)
Power Consumption
LW15E23CB : 48W (Max.)
Less than 2W
LW17E24CB : 58W (Max.)
➣
This set automatically returns to normal operation when horizontal and vertical sync return.
This occurs when you move the computer’s mouse or press a key on the keyboard.
Troubleshooting: Before Contacting Service Personnel
On PC mode, image is not stable and
may appear to vibrate.
On PC mode, image is not centered
on the screen.
You need the Monitor driver software.
◆ Check that the display resolution and frequency from your
computer or video board is an available mode for your set.
On your computer check: Control Panel, Display, Settings.
◆ If the setting is not correct, use your computer utility programme
to change the display settings.
➣
Your set supports multiscan display functions within the
following frequency domain:
Horizontal frequency - 15” : 30 ~ 69 kHz
17” : 30 ~ 81 kHz
Vertical frequency - 56 ~ 75 Hz
Maximum refresh rate - 15” : 1024 x 768 @ 75Hz
17” : 1280 x 1024 @ 75Hz
◆ Adjust the horizontal and vertical position.
◆ Download the driver from WWW pages:
http://www.samsungusa.com/monitor
http://www.samsung-monitor.com