Filter
Top Products
English-9
To view TV channels correctly, a signal must be received by the set
from one of the following sources:
◆ An outdoor aerial
◆ A cable TV network
◆ A satellite network (see page 10 for further details)
1 In the first three cases, connect the aerial or network input cable to
the 75Ω coaxial socket on the rear of the TV.
2 If you are using an indoor aerial, you may need to turn it when
tuning your TV until you obtain a picture that is both sharp and
clear.
For further details, refer to:
◆ “Automatic Storing of Channels” on page 16
◆ “Manual Storing of Channels” on page 18
➢ If you wish to subscribe to a cable network, contact your
local dealer.
You can connect a VCR to the TV using a:
◆ Coaxial cable
◆ SCART cable
◆ S-Video cable
1 Plug the aerial input cable into the appropriate socket on the VCR.
2 Connect a coaxial cable to the:
◆ VCR aerial output socket
◆ Television aerial input socket
3 To obtain better picture quality and, in addition, simplify the setting
up procedure of the VCR, you can connect a SCART cable
between:
◆ The AV (SCART) socket on the VCR
and
◆ A SCART socket on the rear of the TV
4 Follow the instructions supplied with your VCR to tune the VCR to
your TV.
ATT.
M
A
IN FROM
ANT.
OUT TO TV
DECODER
AV
TEST
M
A
L
G
COUL N/B
or
Cable Television
Network
Rear of the TV
Rear of the TV
Aerial output
SCART cable
Aerial input
Connecting to an Aerial or Cable Television Network
Connecting a non-AV-Link VCR