Filter
Top Products
134
Network
7
7 Network
access the Internet so you do not have to enter them manually. Most home networks are Dynamic
Networks.
Some networks require a Static IP address. If your network requires a Static IP address, you must
enter the IP address, subnet mask, gateway, and DNS values manually on your product Cable
Setup Screen when you set up the network connection. To get the IP address, subnet mask,
gateway, and DNS values, contact your Internet Service Provider (ISP). If you have a Windows
computer, you can also get these values through your computer.
You can use ADSL modems that support DHCP if your network requires a Static IP address. ADSL
modems that support DHCP also let you use Static IP addresses.
7.1.2 Wired Network Settings
MENU Network Network Settings ENTER
Set the network connection to use Internet services such as perform software upgrades.
Automatic Network Setup
Use the Automatic Network Settings when connecting your product to a network that supports DHCP.
To set up your product cable network connection automatically, follow these steps.
How to set up automatically
1 Go to the Network Settings screen.
2 Select Wired, press [ ], and then press [ ] again.
3 The network test screen appears and verifies the network connection. When the connection has
been verified, the “Internet is connected successfully.” message appears.
z If the connection process fails, check the LAN port connection.
z If the automatic process cannot find the network connection values or if you want to set the
connection manually, go to the next secton, Manual Network Setup.
O
/FUXPSL4FUUJOHT
8JSFE
8JSFMFTT(FOFSBM
1SFWJPVT
/FYU
$BODFM
8141#$
0OF'PPU$POOFDUJPO
$POOFDUUPUIFOFUXPSLVTJOH
-"/DBCMF1MFBTFNBLFTVSF
UIBUUIF-"/DBCMFJT
DPOOFDUFE
4FMFDUBOFUXPSLDPOOFDUJPOUZQF
$
POOFDUUPUIFOFUXPSLVTJO
H
-
"/DBCMF
1MFBTFNBLFTVS
F
UIBUUIF-"/DBCMFJ
T