Filter
Top Products
2-8
7. Check if BRACKET-HDD has been fixed to the product and connect both the power supply
cable and the signal transmission cable (IDE CABLE) to the HDD.
Signal Transmission Cable
(IDE Cable)
Power Supply Cable
6. Reattach HDD to the original position of BRACKET-HDD.
(Assembly shall be done in the reverse procedure of disassembly as follows. Align the 5
fixing points at the bottom with the BRACKET-HDD fixing holes respectively and push
BRACKET-HDD out of the product to align the screw fixing holes. Then, tighten the screws
firmly.)
SHR-2040/2041/2042-ENG-1 2005.6.29 4:58 PM Page 2-8