Filter
Top Products
11
User’s Guide
10
18) HOLD(SEQUENCE)
This is used when stopping the Switching mode of the SEQUENCE,
TOUR, and SALVO of the Matrix Switcher.
It is equivalent to “SEQUENCE” button in the Multiplex control
mode.
19) NEXT(FREEZE)
This is used when proceeding the visuals one step at a time in the
Switching HOLD Mode of the Matrix Switcher.
It is equivalent to “FREEZE” button in the Multiplex control mode.
20) BEFORE(ZOOM)
This is used when returning the visuals one step at a time in the
Switching HOLD Mode of the Matrix Switcher.
It is equivalent to “ZOOM” button in the Multiplex control mode.
21) ENTER
This is used when deciding the selected item or the set-up value.
It is equivalent to “ENTER” button in the Multiplex control mode.
22) DC9V 0.6A
This is the DC9V power input terminal.
23) IN-RX-OUT
As being for RS-485 communication, this is connected to the
Samsung Dome Camera,Receiver Unit, Multiplex or the RS-485
terminal of a different Controller.
24) MATRIX
This is connected to the RS-485 terminal of the Matrix Switcher.
MATRIX
IN RX OUT
DC 9V 0.6A
24 23 22
11) AUTO PAN
This is used when repeatedly moving the two spots of the Pan/Tilt
connected to the Samsung Dome Camera or the receiver unit.
When you select the AUTO PAN Mode, LED gets turned on and
when you come out LED gets turned off.
12) RESET(RESET/ERASE)
This is used when canceling the ALARM Mode in a condition in
which an ALARM has occurred.
It is equivalent to “RESET/ERASE” button in the Multiplex control
mode.
13) AUX1, AUX2, AUX3, AUX4(SET, LIST, REC CHECK,
LIVE/P.B.)
This controls the AUX output of the Receiver Unit
It is equivalent to “SET”, “LIST”, “REC CHECK” and “LIVE/P.B.”
button in the Multiplex control mode.
14) SEQUENCE(MULTI SCREEN)
This is used when executing the Sequence switching actions set up
in the Matrix Switcher. Also, if you press this button in the SALVO
Mode, it becomes SALVO Switching Mode.
It is equivalent to “MULTI SCREEN” button in the Multiplex control
mode.
15) TOUR(TRIPLEX)
This is used when executing the TOUR Program set up in the Matrix
Switcher.
It is equivalent to “TRIPLEX” button in the Multiplex control mode.
16) SALVO(PIP)
This is used when executing the SALVO Program set up in the
Matrix Switcher.
It is equivalent to “PIP” button in the Multiplex control mode.
17) MUX CONTROL
It is used for the Multiplex control mode.
SSC-1000 (gb) 2009.1.8 1:38 PM Page 10