Filter
Top Products
41
GB
TV System Conversion
You can convert the input signal into the desired TV system.
1 Connect the RCA audio/video cable into the LINE 1 IN jacks on
the front of the VCR.
2 Press the INPUT SYSTEM button on remote control to select the
input signal. (Initial mode is AUTO)
◆ When the Auto mode is selected, the input signal is
automatically identified.
◆ When the input signal is not automatically identified, select the
corresponding input system.
3 If you wish to convert the NTSC TV system into the PAL system,
select AUTO or NTSC system with the INPUT SYSTEM button on
remote control.
Result
: The display panel shows the NTSC input signal and
the NTSC output signal.
◆ If the input signal does not correspond to the input
button on the VCR, an abnormal signal is outputted.
4 Press the PAL output system button on the VCR.
Result
: The display panel shows the NTSC input signal and the
PAL output signal, and the NTSC signal is converted
into the PAL signal for output.
You can perform playback conversion of the signal recorded on the
tape into the appropriate format for the country.
1 If you wish to convert a PAL system tape into the NTSC system
for playback, then press the NTSC output button on the VCR.
Result
: The display panel shows NTSC output signal.
2 Insert the video tape into the VCR.
◆ is shown on the display panel.
◆ A video tape without the record protect (safety) tab intact will
play back automatically.
3 Press the PLAY ( ) button.
Result
: The TV system recorded on the tape is automatically
read, and the PAL signal is converted into the NTSC
signal for playback.
Playback Conversion
INPUT
SYSTEM
O
S
OK
2
4
1
3
SV-5000W/SECA4 4/1/1 12:19 AM Page 41