Filter
Top Products
EN 24
Native (for PC mode only)
Detects the resolution of the signal of the image and it
will be shown on the screen with same amount of pixels.
Setting the picture size
You can change to a variety of picture sizes—
Natural, Full, Zoom, Cinema, Native (For PC
mode only).
Selecting the picture size
1
Select “Picture ⇒
Advanced Settings ⇒ Picture
Size
”.
2
Press
◀ or ▶
to select the desired picture size, as
described below.
NOTE:
Selectable picture sizes may vary depending on the
input source or broadcast signal.
You can be select desired size of picture by
pressing PICTURE SIZE on the remote control.
•
•
Natural
In some cases, this image will display the size of
standard 4:3 with a black side bar.
Full
Full will display the picture at the maximum size.
Zoom (for letter box programs with
subtitles)
To fill the width of the screen, it is extended
horizontally. However; it is only slightly extended at the
top and the bottom.
The top and bottom edges of the picture may be hidden.
A B C D E F G - - - - - - - - - - - - - - - - A B C D E F G - - - - - - - - - - - - - - - -
Cinema (for letter box programs)
The entire picture is uniformly enlarged—it is
stretched the same amount both wider and taller
(retains its original proportion).
The top and bottom edges of the picture may be hidden.
A B C D E F G - - - - - - - - - - - - - - - -
Full
J3QE0121A_EN.indd 24J3QE0121A_EN.indd 24 12/14/12 6:03:41 PM12/14/12 6:03:41 PM