Sanus Systems VMF TV Mount User Manual


 
Concrete, brick and concrete block in-
stallation:
Use the Wall Plate (a) as a template to mark 2
hole locations on the wall. Always locate Con-
crete Anchors (j) in the brick, block, or concrete.
Never drill into the mortar between blocks!
Carefully pre-Drill these holes with a 1/2” ma-
sonry bit to at least 2.5” in depth. Insert a Con-
crete anchor into each of these holes. Make sure
the anchor is seated completely ush with the
concrete surface even if there is a layer of dry-
wall or other material in front. Insert a Lag Bolt
into each Anchor and tighten until they protrude
1/4 inch from the wall.
Attaching the Monitor Plate to the TV:
Mount the assembly to the back of your LCD
television using the M4 Bolts (h) as shown in
Diagram 2. Place the four M4 Bolts through the
holes in TV Mount Plate (b) and tighten into the
VESA bolt mounting pattern on the back of the
television.
Final Assembly:
Next hang the assembly over the Lag Bolts (g)
using the key-holes in the Wall Plate as shown
in Diagram 3. Once the Wall Plate slides down
over the Lag Bolts, rmly tighten them with the
Allen Key (j).
Diagram 1b
g j
a
concrete or brick surface
Diagram 2
h
b
Diagram 3
Wall
TV
g
Sanus Systems • 2221 Hwy 36 West, St Paul, MN 55113 • 11.15.06 (6901-100048)
Customer Service: 800.359.5520 • See complementary Sanus products at www.sanus.com