Filter
Top Products
37
ENGLISH
To connect the TV to a PC (Personal Computer)
NOTE: Before connecting any cables, disconnect
the AC Power Cords of both the TV and Personal
Computer from the AC outlets.
1
Connect an RGB cable from the monitor output (a)
on your PC to the RGB connector on the TV and
tighten the screws. (Monitor Cable not supplied.)
NOTE:
If Computer has only DVI Output (b), a DVI to RGB
converter will be required (converter not included).
2
Insert one end of a Stereo Mini-Audio cable into
the PC Audio Out jack and the other end into the
PC/DVI AUDIO Input jack. (Stereo Mini-Audio
Cable not supplied.)
HINT:
Volume can be adjusted both from the PC and the TV
VOL +/–.
3
Press the INPUT SELECT on your Remote
Control to step through signal inputs to select PC.
4
Press the SETUP/TV MENU to display the TV’s
PC Setting Menu. Select “Auto Adjust”.
NOTE:
Power on the TV and any other peripheral
equipment before powering on the computer.
NOTE:
Save and close all documents, in case computer might need to be restarted.
Before connecting your computer to your TV, please refer to the following chart to set to a compatible
resolution.
A Refresh Rate value of 60 Hz on your computer is recommended for your TV.
•
•
•
Rear of the unit
RGB
DVI JACK
(a) (b)
VGA cable (not supplied)
Audio cord (not supplied)
RESOLUTION ASPECT RATIO REFRESH RATE
(Hz)
HORIZONTAL
FREQUENCY
(kHz)
VERTICAL
FREQUENCY (Hz)
640 x 480 4:3
60 31.47 59.94
72 37.86 72.81
75 37.50 75.00
720 x 400 18:10 70 31.47 70.00
800 x 600 4:3
56 35.16 56.25
60 37.88 60.32
72 48.08 72.19
75 46.88 75.00
1024 x 768 4:3 60 48.36 60.00
1280 x 768 15:9 60 47.78 59.87
1280 x 720 16:9 60 45.00 60.00
1360 x 768 16:9 60 47.71 60.00
Connections to other equipment
56Q0221A_eng.indd 3756Q0221A_eng.indd 37 1/13/11 2:25:00 PM1/13/11 2:25:00 PM