Filter
Top Products
5
Need help? www.sanyoctv.com 1-800-877-5032
GETTING STARTED
Install two (2) “AAA” batteries in the remote
control. (Not included)
To ensure safe operation, please observe the
following precautions:
• Replace both batteries at the same time. Do not use a
new battery with a used battery.
• There’s a risk of explosion if a battery is replaced by
an incorrect type.
• Do not expose the Remote Control unit to moisture
or heat.
• Be sure to match the “+” and “
–” signs on the
batteries with marks inside the remote control.
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
ANTENNA
CABLE
ANALOG / DIGITAL
ANTENNA IN
BATTERY INSTALLATION
Hook up your antenna or your cable service to
the HDTV’s ANT terminal with the use of a 75
OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away
from the television set and any other electronic
equipment.
The tuner in this HDTV can receive:
• Digital and Analog off air signals from an antenna
• Analog or ClearQAM cable channels from a direct
Cable TV connection.
STAND BASE ASSEMBLY
IMPORTANT NOTE:
Place HDTV face down on a padded or cushioned
surface that is larger than the screen size to
protect the screen and finish. Handling by more
than two people is recommended.
Tools Needed: Phillips screwdriver No. 3
1
Carefully insert the stand base to the bottom of
the HDTV as shown.
2
Secure the stand base with the two (2) screws
supplied in the literature package.
CAUTION: Wall mounting of the HDTV must be
performed by a skilled person.
Use the screws that are threaded into the four (4)
inserts on the back of your Plasma HDTV to
secure it to a wall mounting kit (not included.)
UNIVERSAL standard interface: 400 x 280
Mounting screws measurements:
M6 Diameter, Length—12mm (max.)
WALL MOUNTING
HDTV BACK
NOTE: Do not assemble the stand base if you are wall
mounting the HDTV.