Sanyo DP50710 Flat Panel Television User Manual


 
5
Need help? www.sanyoctv.com 1-800-877-5032
GETTING STARTED
Install two (2) “AAA” batteries in the remote
control. (Not included)
To ensure safe operation, please observe the
following precautions:
Replace both batteries at the same time. Do not use a
new battery with a used battery.
There’s a risk of explosion if a battery is replaced by
an incorrect type.
Do not expose the Remote Control unit to moisture
or heat.
Be sure to match the “+” and
signs on the
batteries with marks inside the remote control.
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
ANTENNA
CABLE
ANALOG / DIGITAL
ANTENNA IN
BATTERY INSTALLATION
Hook up your antenna or your cable service to
the HDTV’s ANT terminal with the use of a 75
OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away
from the television set and any other electronic
equipment.
The tuner in this HDTV can receive:
Digital and Analog off air signals from an antenna
Analog or ClearQAM cable channels from a direct
Cable TV connection.
1
Place HDTV face down on a padded or
cushioned flat surface to protect the screen
and finish
2
Remove the four (4) screws securing the foot
stand. CAUTION: Hold the stand firmly as you
remove the last screw.
STAND REMOVAL ____________
1
Place HDTV face down on a padded or
cushioned flat surface to protect the screen
and finish
2
Carefully insert the stand base to the bottom
of the HDTV and secure the base by inserting
4 screws as indicated in the above diagram.
NOTE: If your HDTV came packed with the Stand Base
unassembled, these screws will be found in the
literature package.
STAND ASSEMBLY ___________
Wall mounting of the HDTV must be performed
by a skilled person.
Use the screws that are threaded into four (4) of
the six (6) inserts on the back of your Plasma
HDTV to secure it to a wall mounting kit (not
included.)
VESA standard interface: 480 x 200 and 480 x 360
Mounting screws measurements:
M6 (6mm) Diameter, Length—12mm (maximum)
WALL MOUNTING ____________