Filter
Top Products
DIGITAL AV CONNECTIONS
9
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
1
Connect DVD Player or similar digital equipment’s
Component Video Out to the DTV’s Component
Video Input jacks.
2
Connect DVD Player or similar digital equipment’s
Audio Out to the TV’s Audio Input jacks.
3
Press POWER to turn on the TV, then turn on
external equipment.
4
Press INPUT to select
Component2
to view the DVD
program.
USING COMPONENT JACKS TO
CONNECT A DVD PLAYER OR OTHER
DIGITAL EQUIPMENT
The Component Video jacks will accept any video
content.
Switch off DTV and external equipment before connect-
ing cables.
(Cables are not supplied.)
Follow these steps
to easily connect your STB or DVD Player to this DTV:
DVD PLAYER
(or similar
digital device
such as a
Satellite
Receiver.)
COMPONENT
JACKS
1
What you will need
for connections:
Component Video Cable – 1
Audio Cable – 1
■ Press the INPUT key after connecting the cables, to select the
Com-
ponent2
input signal. There is NO need to tune to a blank channel.
■
“
No Signal” will appear randomly on the screen when no signal is
detected at the VIDEO2 (Y, Pb, Pr) inputs.
■ Position your DTV at least 2 feet from stereo speakers. The magnets
in the speakers may affect the picture quality.
2
CONNECTING DIGITAL AUDIO OUT
JACK TO A MULTI-CHANNEL
RECEIVER
Dolby
®
Digital Audio provides 5.1 channels of surround
sound (five full-range channels [5] and one low-frequency
effect channel [.1]). A fiber optics cable is used to carry
the 5.1 surround sound (for low-noise signal transfer).
BACK VIEW
OF DTV
OPTICAL
DIGITAL CABLE
1
Using a Fiber Optics cable, connect the DTV’s Digital
Audio Output to the Digital Audio Input of a Multi-
Channel Receiver.
(Fiber optics cable is not supplied.)
2
Press POWER to turn on the DTV, then turn on exter-
nal equipment.
NOTES:
When making the connection, do not pinch or kink the fiber
optics cable.
Red light visible at the Digital Audio Output does not nec-
essarily indicate that Dolby
®
Digital 5.1 audio is available.
Digital audio is made up of light pulses that the human eye
cannot detect. Dolby
®
Digital 5.1 audio is available at the
Digital Audio Output only when received as part of a Digital
signal.
What you will need for
connections:
Optical Cable – 1
MULTI-CHANNEL
RECEIVER
1
REMOTE CONTROL
4
3
REMOTE CONTROL
2
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
Channel Search twice before you can select the AV inputs.
DTV
BACK
IMPORTANT NOTE:
These jacks accept
only 480i (standard
intelaced) signals.