Filter
Top Products
6
CONNECTING LCD TV
Be careful of the panel. Suggest to put down the panel side on the cushion or other soft material before installing
the stand.
To align the corresponding pilot holes and fix the stand by screws.
Screws (M4x8) for LCE-24C100F(K)/(N)/(R)/(S): 2 pcs
Please according to the following procedure to install stand.
2
1
Installing of stand is completed.
3
Model LCE-24C100F(K)/(N)/(R)/(S):
This LCD TV uses nominal input voltages of 110-240V
AC. This LCD TV
automatically selects the correct input voltage. It is designed to work with single-
phase power systems. To reduce risk of electrical shock, do not plug into any
other type of power system. Consult your authorized dealer or service station if
you are not sure of the type of power being supplied.
Connect the LCD TV with all peripheral equipment before turning the LCD TV on.
CAUTION
For safety, unplug AC power cord when the LCD
TV is not in use.
To the AC Outlet (110 - 240V AC).
Pulls the AC power cord out from
the LCD TV.
The AC outlet must be
near this equipment and must be
easily accessible.
AC POWER CORD
CAUTION IN INSTALLING & UNINSTALLING STAND BASE
●
Through in installing or uninstalling work, handling with more than two people is recommended.
●
When holding (moving or lifting) the LCD Display, hold the display's body.
Do not handle the LCD
TV by holding the attached accessory parts,
otherwise it may result in damage.
●
Before installing or uninstalling, provide a desk (or a part of it) which is strong enough to support the weight of
the LCD TV and this stand. The
desk must be larger than the LCD
Display screen size. The desk's
surface must be flat and maintained with
soft material (such as a blanket) for
protecting the screen
surface.
●
Before putting the LCD Display on the desk, make sure there is no object on it. Leaving any object under the screen may cause damage on the
screen.
●
The LCD TV with this stand should be installed or uninstalled on
flat and level place. Do not place on such as
a non flat, unlevel or unstable cart or
stand. The display may fall,
causing not only serious damage
to the products but serious injury to a person.
SAFETY NOTE
For correct installing, mounting and uninstalling LCD TV Stand, it is strongly recommended to use a trained, authorized dealer. Failure to follow
correct procedures could result in damage to the equipment or injury to the installer.
INSTALLING & UNINSTALLING STAND BASE
CONNECTING AC POWER CORD
Note:
AC Power Cord types vary between countries.
Screw M4 X 8 :
Screw : M4 X 8
Screw : M4 X 8