Filter
Top Products
39
APPENDIX
There are tiny black
points and/or bright
points on the PDP.
● There may be some tiny black points and/or bright points on the PDP (Plasma Display
Panel). These points are normal.
Problem: Try these Solutions
WARNING :
High voltages are used to operate this Plasma Monitor. Do not attempt to open the cabinet.
If the problem still persists
after following all operating instructions,
contact the sales dealer where you purchased the
Plasma Monitor or the service center.
Give the model number and explain the difficulty. We will advise you how to obtain
service.
The POWER
indicator is flashing.
(No power)
● When the Plasma Monitor has some trouble, self diagnose function activates.(P40)
FUNCTIONS OF PRODUCT SAFETY FEATURES
When the temperature of inside the Plasma Monitor becomes high, the cooling fans start operating automatically
to cool down the Plasma Monitor. The fan's running speed is changed according to the inside temperature of the
Plasma Monitor. When the Plasma Monitor has cooled down, the fans stop running.
When the message above is displayed, the internal cooling fans have some trouble. This message is displayed
for 10 seconds in every 10 minutes. If this message is displayed frequently, contact sales dealer where you
purchased the Plasma Monitor or the service center.
"Warning! Internal fan is in trouble, not working properly."
COOLING FAN
For protecting product safety, protection features provided inside the Plasma Monitor. Each feature operating as
follows ;
When the temperature inside the Plasma Monitor is abnormally high, the Plasma Monitor will be turned off
automatically after displaying the message below.
"Warning! Internal temperature is too high."
INTERNAL TEMPERATURE MONITOR
When this message is displayed, the internal temperature of the Plasma monitor exceeds normal. The Plasma
Monitor will be turned off automatically after displaying this message for 10 seconds. When the Plasma Monitor
has been cooled down and the temperature returns to normal, the Plasma Monitor can be turned on again by
pressing the POWER button.
If the message is displayed frequently, contact sales dealer where you purchased the Plasma Monitor or the
service center.