Filter
Top Products
AUTOREPEAT RECORDING
Autorepeat Recording
The same tape can be recorded over many times.
œ Follow the Before starting steps, under “NORMAL
RECORDING”.
1 Press the MENU button to display the MAIN MENU.
2 Press the l (or j) button to select the “3.GENERAL
SET” line, then press the ENTER button.
ø The (GENERAL SET) menu appears.
<GENERAL@SET>
TAPE@IN@MODE@@@@@STOP
TAPE@END@MODE@@@@REW
CLOCK@ADJUST@@@@@01:00
THREAD@CHECK@@@@@N
VIDEO@LOSS@@@@@@@N
CLOG@DETECT.@@@@@N
REMOTE@@@@@@@@@@@MENU
VIDEO@@@@@@@@@@@@COLOR
VERTICAL@SYNC@@@@Y
TAPE@@@@@@@@@@@@@T-160
3
Press the l (or j) button until the “TAPE END
MODE” setting is highlighted, then press the ENTER
button.
4
Press the l (or j) button to set to “REPEAT1” or
“REPEAT2” (Refer to “Setting the Mode at the End
of the Tape.” on page 23), then press the ENTER
button.
5
Press the MENU EXIT button.
ø The REPEAT indicator lights.
6
Press the REC/PLAY SPEED l button to set the
recording speed mode.
7
Press the REC button.
ø Recording starts. When the tape end is
reached, the VCR will rewind it to the
beginning, and recording will resume.
ø When the end of the tape is reached, “OFF” will
be displayed and TAPE END OUT terminal
output will 0 V, until the rewinding operation
starts.
NOTES:
œ If there is an alarm trigger during autorepeat
recording, “AL” and “A” flash on the digital display and
alarm recording starts. (Refer to “ALARM
RECORDING” on page 25.)
œ If the “TAPE END MODE” setting is “REPEAT1”, the
REPEAT indicator will go off if there is an alarm
trigger. After alarm recording, the recording will
continue to the end of the tape then it will be rewound
to the beginning and stop. “OFF” will be displayed on
the digital display.
To turn off the “OFF” display, press the STOP,
EJECT, FF, REW or PLAY button.
œ If “AL” appears on the digital display and the “TAPE
END MODE” setting is “REPEAT1”, autorepeat
recording is not possible.
NB4QR/NA (SRT-4040 GB) Tue. Sept., 10/2002
24
English