Filter
Top Products
24
ANTENNA
TERMINAL
BACK OF TV
CABLE
A/V JACKS
FRONT AV JACKS
BACK OF VCR
IN
OUT
OUTPUT
CH3
CH4
R–AUDIO–L VIDEO
S-VIDEO
YC
B CR
ANT. 75Ω
Y
MONITOR OUT
AV1/DVD
CR
CB
R
L
(MONO)
VIDEO
R
L
INPUT
V
D
E
O
I
CAMCORDER
■ To watch video input picture, select AV1
position by pressing the TV/AV key.
AV1
■ To watch video
input picture,
select AV2
position by
pressing the
TV/AV key.
AV2
Note: Model ST-21SF1 / ST-21SF1K is not
equipped with Front AV2 input terminal
USING THE AUDIO/VIDEO INPUT JACKS
You can connect your VCR, camcorder, video game, stereo system, etc. directly to the
TV using the Audio and Video jacks. Be sure to switch off TV and external equipment
before connecting cables. Make sure all cable connectors are fully seated on the jacks to
avoid possible signal loss and audio hum. (Cables are not supplied.)
CONNECTING AUDIO VIDEO INPUT JACKS
•
Connect the video output from the external equipment to the TV’s video input jack.
•
Stereo (R/L) audio: Connect the right and left audio output from the external equipment to
the TV’s right and left audio input jacks.Then select “STEREO” channel of the audio
channel in the TV set with the AUDIO menu setting in AV mode.
If the external audio signal is a monaural one in this connection, please use “Mono to
Stereo Adapter” (not supplied) and connect to TV set. Note: AV stereo in AV mode always
fixed on “STEREO” channel
•
Mono (single jack) audio: Connect the audio output from the external equipment to the
TV’s left (L) audio input jack.
OM BE4P-E (FC8-A) 1/4/10 8:50 AM Page 24