Filter
Top Products
Connecting to an HDTV with a DVI Connector
Required cables:
• 1 HDMI-to-DVI or 1 HDMI-to-HDMI cable and 1 DVI adapter
• 1 audio Left/Right cable
Notes:
• When you connect the HDMI connector to the DVI connector on your HDTV, you need an HDMI-
to-DVI adaptor and a separate audio connection.
• Digital content is encrypted with High-Bandwidth Content Protection (HDCP) on the DVI/HDMI
port. This set-top is not compatible with devices that do not support HDCP. You must use
either the PrPbY or 1394 connection (which uses Digital Transmission Content Protection, or
DTCP) to connect the set-top to these devices.
• Also refer to the Important Notes Regarding the HDMI Interface on the Set-top on page 12.
13
WARNING:
Electric shock hazard! Unplug all electronic devices before connecting or disconnecting
any device cables to the set-top.
T12969
Explorer Set-top
IR
THIS DEVICE IS INTENDED TO
BE ATTACHED TO A RECEIVER
THAT IS NOT USED TO RECEIVE
OVER-THE-AIR BROADCAST
SIGNALS. CONNECTION OF THIS
DEVICE IN ANY OTHER FASHION
MAY CAUSE HARMFUL
INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN
VIOLATION OF THE FCC RULES,
PART 15.
120 VAC
60HZ 400W
LISTED 14H1
CABLE EQUIP.
120 VAC
60HZ 40W
CABLE
IN
1394
S - VIDEO
OUT
OPTICAL
AUDIO OUT
USB
CABLE
OUT
VIDEO
OUT
DIGITAL
AUDIO OUT
AUDIO OUT
HDTV
Pr
Pb
Y
1394
L
R
eCM MAC: 001868C16907
STB RF MAC: 001868C16906
STB SN: SABNFSRVG
MULTI-STREAM CABLE CARD
AVI S:
RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR
CATV CONVERTER
MADE IN MEXICO
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Back of HDTV
DVI/HDCP
IN
AUDIO
CENTER
CHANNEL IN
AUDIO IN
DVI/HDCP
ANT (75 )
INOUT
LR
ANT-1
HD 2
Y
OUT
ANT-2
PB
PR
L
R
VIDEO
L/
MONO
R
L/
MONO
R
AUDIO
IN
ON OFF
S-VIDEO
VIDEO
AUDIO
HD 2
Y
PB
PR
L
R
AUDIO
Cable Input