Filter
Top Products
ENFORCER DR-1 Series DVR Quick Setup Guide
6 SECO-LARM U.S.A., Inc
4. To adjust the time and date:
Note: Changes to time and date settings may cause inconsistency or data loss in previously
recorded material. Back up all data before making changes. For more information on how
to back up data, please see Exporting Video on pg. 11 of this guide.
a. Enter the system menu and select System Setup .
b. Select Date/Time.
c. Select Date. The year will flash. Press the up/down arrows on the device front panel or
remote control, or scroll up and down with the mouse scroll wheel. Repeat for month and
day settings.
d. Select Time. Adjust the time in the same manner as described in part c. above.
e. Select Time Zone. Adjust the time difference to match the UTC (Coordinated Universal
Time) offset in your area. For example, Los Angeles is 8 hours behind UTC, so the UTC
offset is -8:00.
f. For other features such as Daylight Saving Time and Network Time Protocol please see
the User’s Manual section 3.4 System Date / Time Setting.
5. To adjust the system language:
a. Enter the system menu and select System Setup .
b. Select Language. Press the up/down arrows on the device front panel or remote control,
or scroll up and down with the mouse scroll wheel. The language will change immediately.
Press ENTER or left click to confirm your selection, or press ESC or right click to keep the
previous language setting. There are 23 different language options.
Basic Network Setup:
1. Enter the system menu and select System Setup . Be sure the DVR is connected to a
network via an Ethernet cable.
2. Select Network Setup.
a. Select LAN Select. If the DVR connects to a local area network, choose LAN (default).
b. If the DVR connects directly to the internet, choose PPPoE. PPPoE users must configure
the following options: PPPoE Account, PPPoE Password, and PPPoE Max Idle.
c. If a connection to a network is not desired, choose None. The DVR will still record data.
d. If a connection to a network is desired, it may be necessary to adjust LAN settings via the
LAN Setup menu (Network SetupLAN Setup). Contact your network administrator for
details about your network.
e. To connect to a network based on DHCP, set the DHCP to ON. The IP address, Netmask,
Gateway, and DNS setting will be retrieved from network servers.
f. For non-DHCP users, set DHCP to OFF. Enter an IP address, Netmask, Gateway, and
DNS settings. This information may be obtained from the network service provider.
3. Press ENTER or left click to confirm your selections, or press ESC or right click to cancel.
Continued from page 5