Filter
Top Products
Important safety and mounting instructions
LAH 500 | 2
X
Rotate the LSP 500 PRO horizontally as desired and then secure this position using the
safety screw of the holder (see fig. 2.3).
X
Use a safety wire to secure the LAH 500 and the LSP 500 PRO to the truss as shown in
fig. 2.3. The safety wire must be rated for the attached load. The safety wire, rope termina-
tions and coupling links must comply in their dimensioning and condition with the regula-
tions and standards of the country in which they are used and must reliably prevent tip-
ping/dropping of the attached parts.
X
Make sure that ...
- the LSP 500 PRO cannot tip over or drop down, even if the power or audio cables are
pulled;
- you replace the safety wires and coupling links by new ones when they have prevented
tipping/dropping;
- you check every 3 months if all screws are tightened with the torques specified in these
safety and mounting instructions and if the LSP 500, the LAH 500, the TV spigot/TV pin,
additional fastening elements, safety wires as well as the coupling links are in proper
condition.
In case of any damage or any deviation from the safety and mounting instructions, immedi-
ately dismount the LSP 500 PRO, the LAH 500 and the additional mounting hardware used.
Package contents
1 upper mounting plate
1 lower mounting plate with spacer (premounted)
2 knurled screws for joining the upper and the lower mounting plate
The Neumann LH 29 TV spigot, the König & Meyer TV pin 24519 and the safety wires have
to be ordered separately.
Specifications
Weight: 2.4 kg
Dimensions: 65 x 190 x 188 mm (H x W x D)
Warranty
Sennheiser electronic GmbH & Co. KG gives a warranty of 24 months on this product.
For the current warranty conditions, please visit our website at www.sennheiser.com or con-
tact your Sennheiser partner.