Filter
Top Products
42
Appendix
Removing the Stand
•
Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
CAUTION
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching the stand
• Before performing work, make sure to turn off the TV.
• To attach the stand, perform the above steps in reverse order.
Unfasten the four screws used to secure the stand in
place.
Detach the stand from the TV.
1 2
• Detach the cable clamp on the rear of the TV when using the optional mount bracket.
• To use this TV mounted on a wall, remove the covers at the 4 locations on the rear of the TV, and then use the screws
supplied with the wall mount bracket to secure the bracket to the rear of the TV.
• Some thicker AV cables may not fi t within the 2
3
/
8
-inch (60 mm) space limitation of AN-65AG1.
Setting the TV on the Wall
CAUTION
• This TV should be mounted on the wall only with the wall mount bracket AN-52AG4 (SHARP) (for LC-60E77UN)
or AN-65AG1 (SHARP) (for LC-65E77UM). The use of other wall mount brackets may result in an unstable
installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualifi ed service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or
mounting that results in accident or injury.
Using an optional bracket to mount the TV
•
You can ask a qualifi ed service professional about using an optional AN-52AG4 or AN-65AG1 bracket to mount the
TV on the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-52AG4 or AN-65AG1
wall mount bracket.
(See the bracket instructions for details.)
About setting the TV angle
0/5/10°
AN-52AG4
LC-60E77UN
• The center of the display:
1
63
/
64
inches (50.0 mm) above
the “ f ” position.
AN-65AG1
LC-65E77UM
• The “A” position is at the center
of the display.
• Refer to the operation manual
of AN-52AG4 or AN-65AG1 for
details.
Vertical mounting Angular mounting