Filter
Top Products
44
Dimension: 140 X 215 mm
Operation of Universal Remote Control (Continued)
•
How to identify a cable converter
Direct Entry Method
Refer to the following steps and list to quickly
find the remote control code for your cable TV
converter.
• First look up your converter’s remote code
number before going through the Direct Entry
Method below.
• If this procedure does not identify your
converter, use the Search Method for
identification.
(1) Slide CATV /DVD-TV/VCR switch to CATV.
(2) Press and hold down DISPLAY
and CH s on
your remote control.
Then release both buttons.
(3) Within 10 seconds after releasing DISPLAY
and CH s, enter your converter’s two-digit
code number using REMOTE KEYPAD (refer
to the list).
• The remote control is now ready to send
commands to your converter.
• Some brands have more than one remote code
listed due to changes in the remote codes from
early to later model years. In such cases, you
may have to try more than one code to find
the code your converter accepts.
Note:
Depending on the model, year produced,
brand, and type of CATV converter, some
models may not be compatible with the remote
control.
Search Method
(1) Slide CATV /DVD-TV/VCR switch to CATV.
(2) Press the power button on the cable converter
to ON.
(3) Stand at least 6 feet away from the converter.
Point the Remote towards the converter.
Hold down the DISPLAY
and CH a at the
same time. KEEP HOLDING THE BUTTONS
DOWN.
(4) Watch the Channel Number indicator on the
converter.
Channel numbers will scan up when the
converter has been identified.
Release the DISPLAY
and CH a as soon as
the channel numbers start to scan up.
The converter’s remote control code number
has been identified, and the remote is ready
to operate the converter.
Tips on identifying your cable converter
Be Patient: A minute or two can seem a lot
longer when you’re waiting for something to
happen, but the code should be identified
within 2 minutes. Remember, it is only a one-
time set-up.
Be careful not to let the CATV converter scan
more than 5 channels when the indicator starts
to move up. If you continue holding down the
DISPLAY
and CH a after 5 channel scans,
the proper remote code can be passed up, and
the 2 minute identifying cycle will have to be
repeated.
If a channel change does not occur on the
cable converter within 2 minutes, read the
identifying instructions again and repeat the
steps. Should a channel change still not occur,
the remote will not operate with the desired
converter.
Note:
Some satellite receivers can be operated by
the REMOTE CONTROL. If you have a
Satellite Receiver, you can use the above
method to search for available channels.
Anvision
Cable Star
Eagle
General Instrument
Jerrold
Magnavox
Oak Sigma
Panasonic
Philips
Pioneer
Randtek
RCA
Scientific Atlanta
Sony
Viewstar
Zenith
07, 08
07, 08
08
04, 05, 15, 23, 24, 25,
30, 36
04, 05, 15, 23, 24, 25
30, 36
07, 08, 19, 25, 28, 29,
32, 33, 40, 41
18
27, 39
07, 08, 19, 26, 28, 29,
32, 33, 40, 41
18, 20
07, 08
27, 43
03, 22, 42
44
07, 08, 19, 26, 28, 29
32, 33, 40, 41
14
CATV CONVERTER
BRAND
REMOTE CONTROL
CODE NUMBER
32UF5/6 44