Sharp LC-32B20S Flat Panel Television User Manual


 
Watching TV
TV indicator status
B indicator
Status
Off Power off
Green Power on
Red Standby
NOTE
If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the power outlet.
A small amount of electric power is still consumed even
when a is turned off.
Changing channels
With Pr/Ps: With 0 - 9:
Switching between analogue and
digital broadcasts
Selecting external video source
Once the connection is made, press
b to display the INPUT SOURCE
screen, and then press a/b to switch
over to the appropriate external source
with OK.
INPUT SOURCE
TV
EXT1
EXT2
EXT3
EXT4
EXT5
INPUT SOURCE
TV
EXT1
EXT2
EXT3
EXT4
EXT5
Selecting Sound mode
DTV mode:
E
If multi sound modes are received, each
time you press 2 the mode switches as
follows.
Audio (ENG) : STEREO
L/R L R LR
Audio (ENG) : CH A
CH A CH B CH AB
Audio (ENG) : MONO
E
Press c/d to select L or R sound when
the STEREO or DUAL MONO screen is
displayed.
Audio (ENG) : STEREO
L/R L R LR
NOTE
The sound mode OSD disappears in 6 seconds.
Selectable items vary depending on the received
broadcasts.
ATV mode:
Each time you press 2, the mode switches as
illustrated in the following tables.
NICAM TV broadcasts selection
Signal Selectable items
Stereo
NICAM STEREO, MONO
Bilingual
NICAM CH A, NICAM CH B, NICAM CH AB,
MONO
Monaural
NICAM MONO, MONO
A2 TV broadcasts selection
Signal Selectable items
Stereo
STEREO, MONO
Bilingual
CH A, CH B, CH AB
Monaural
MONO
NOTE
When no signal is input, the sound mode will display
“MONO”.
However, please bear in mind
that EPG data (electronic
programme guide) will be
lost, and programmed
timer recordings will not be
performed by the TV.
Daily operation
Switching on/off
Turning on/off the power
Press a on the TV.
Switch it off by pressing a on the TV.
E
Watching analogue
broadcasts
E
Watching digital
broadcasts
Standby mode
E
To standby mode
If the TV set is switched on, you can switch it to
standby by pressing B on the remote control.
E
Switching on from standby
From standby, press B on the remote control.
10