Filter
Top Products
Connecting external devices
NOTE
In cases when the decoder needs to receive a signal from
the TV, make sure to select the appropriate input terminal
to which the decoder is connected in “Input Source” (Page
10).
•
SCART connection
Example of connectable devices
● VCR ●
Decoder (only SCART 1)
●
DVD player/recorder
HDMI (DVI) Connection
ø 3,5 mm stereo mini jack cable
HDMI 1 or 2
HDMI-certified cable
DVI/HDMI Cable
PC connection through HDMI (DVI)
LC-37DH77E_ES.indd 16 2008/12/16 13:50:06
SCART 1
(AV / RGB)
Speaker/amplifier connector
Connect an amplifier with external speakers as shown
below.
15
SCART cable
Decoder
DIGITAL AUDIO IN
SPDIF
DIGITAL
AUDIO
OUTPUT
SPDIF
Audio cable
Amplifier with
digital audio input
●
● After connection
● If after connecting a PC to the TV through a
HDMI cable, the audio does not run, connect a mini
stereo connector of ø 3.5mm between TV and PC
as indicated in the previous drawing.
● When a PC is connected to the TV with a DVI
cable, it will be necessary to connect a mini stereo
connector of ø 3.5mm of the TV to PC as indicated
in the previous drawing
0#
0#
LC-37DH77E_ES.indd 35 2008/12/16 13:50:34
AUDIO IN
HDMI (DVI)
●
● After connecting
Digital audio output setting
After connecting an amplifier with digital audio
input and external speakers as shown, you should
set an audio output format compatible with
the programme you are watching or the device
connected.
Go to “MENU” > “SOUND” > “SPDIF Mode”
> select “PCM” or “Dolby Digital”.
NOTE
When you set this to “Dolby Digital”, and you receive
the Dolby Digital or Dolby Digital Plus audio formats,
Dolby Digital audio is output. Otherwise, PCM audio is
output.
When you set this to “PCM”, PCM audio is output no
matter what audio formats you receive.
•
Example of connectable devices
●
Connecting an amplifier with digital audio
input