Sharp LC60LE650U Flat Panel Television User Manual


 
7
• In the installation procedure, be careful not to catch your fi ngers between the
TV set and the fl oor.
Do not remove the stand from the TV unless using an optional wall
mount bracket to mount it.
After attaching the stand to the TV, do not hold the stand when you
put up, set up, move or lay down the TV.
QUICK REFERENCE
LC-70LE657U/LC-60LE657U/LC-70LE655U/
LC-60LE655U/LC-70LE650U/LC-60LE650U/
LC-70C6500U/LC-60C6500U
1
Confirm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
2
1
Set the post for the stand unit onto the
polystyrene foam.
2
Attach the base to the post.
3
Insert and tighten the 8 screws into the 8
holes on the bottom of the base.
• Hold the stand unit securely with one hand,
and then tighten the screws.
LC-70LE657U/LC-70LE655U/LC-70LE650U/
LC-70C6500U
Long screws
FRONT
2
1
1
3
LC-60LE657U/LC-60LE655U/LC-60LE650U/
LC-60C6500U
Long screws
2
1
1
3
FRONT
3
1
Insert the stand into the openings on the
bottom of the TV.
• Make sure that the stand is fi rmly inserted into
the TV. Improper installation may result in tilting
of the TV set.
2
Insert and tighten the 4 screws into the 4
holes on the rear of the TV.
1
2
2
1
Short screws
Soft cushion
Attaching the Stand (for the 90/80 Inch Models)
Building the Work Table
Before attaching the stand to the TV, build a work
table on which to rest the TV.
• To build the table, use the cushioning materials
used in the packaging.
• Of the cushioning materials used, TOP-C is also
used during stand unit assembly. Be sure to
assemble the stand unit before building the work
table.
FRONT
TOP-L
TOP-R
TOP-C
1
Insert each of the cushioning materials in the
respective directions shown in the fi gure.
• Insert TOP-L and TOP-R into the left and right
sides of the case respectively.
• Insert TOP-C to fi t between the lines on the other
side of the case.
TOP-L
CASE
LINE
TOP-R
TOP-C
2
The case is equipped with push-in tabs to
hold the cushioning materials in place. Push
in the tabs (2 for each location) to secure the
cushioning materials in the case.
Push-in tabs
LC-90LE657U
Attach the joints and close the case.
1
Insert a joint into the hole on the side of the case.
2
Pressing the tab, fi x the joint into place.
1
2
TOP-L
TOP-R
JOINT
CASE
LINE
TOP-C
3
After you have built the work table, spread a
blanket or similar soft cloth over the table and
then lay the TV display down on the covered
table before attaching the stand to the TV.
• Do not use a small table for this.
• Refer to the operation manual for information on
attaching the stand.