Filter
Top Products
17
Selecting a sound mode
E
DTV/SAT mode
If multi sound modes are received, each time you
press 7 the mode switches as follows.
Audio (ENG) STEREO
L/R LRLR
CH A CH B CH AB
Audio (ENG) CH A
Audio (ENG) MONO
Press c/d to select L or R sound when the
STEREO or DUAL MONO screen is displayed.
Audio (ENG) STEREO
L/R LRLR
NOTE
• The sound mode screen disappears in six seconds.
• Selectable items vary depending on the received
broadcasts.
• When the “Audio description setting” menu is set
to “On”, the audio description sound is selected
depending on the main audio.
E
ATV mode
Each time you press 7, the mode switches as
shown in the following tables.
NICAM TV broadcasts selection
Signal Selectable items
Stereo
NICAM STEREO, MONO
Bilingual
NICAM CH A, NICAM CH B, NICAM CH AB,
MONO
Monaural
NICAM MONO, MONO
A2 TV broadcasts selection
Signal Selectable items
Stereo
STEREO, MONO
Bilingual
CH A, CH B, CH AB
Monaural
MONO
NOTE
• When no signal is input, the sound mode will display
“MONO”.
Channel display
You can display the channel information by pressing
p on the remote control unit.
DTV mode ATV mode
Audio (ENG) STEREO
Video
Subtitle Off
>> New information
MONO
Auto
Subtitle
I Four digit numbers (e.g., 0001) are displayed after
selecting the five Nordic countries in the country
setting or for some cable operators. Also, operator
profiles use four digits.
SAT mode
Audio (ENG) STEREO
Video
Subtitle Off
>> New information
J Satellite channels are displayed by four digit numbers
(e.g., 0001).
K You can set four satellite stations to “SAT1”, “SAT2“,
“SAT3“, “SAT4”.
E
Time display in channel information
You can display the time information included in
DTV, SAT and teletext broadcasts.
NOTE
• Skip step 1 if receiving DTV/SAT broadcasts.
1 Select a TV channel (the time information is
automatically captured).
2 Press p. The channel display will appear on the
TV.
3 Press p again within the several seconds
that the channel display is on the screen. Time
information will be shown in the lower-right
corner of the screen for several seconds.
4 Even when you change the TV channel, you can
display the time information with steps 2 and 3
above.
Operation without a remote control unit
You can operate the menu settings using the TV
control buttons.
TV control buttons Remote control buttons
@@
b
;
:r/s
a/b
i+/-
d/c
Watching TV