Sharp LC-90LE757RU Flat Panel Television User Manual


 
5
Attaching the stand unit
Before attaching (or detaching) the stand, unplug the AC cord.
Before performing work, spread cushioning over the surface on which you will be laying
the TV. This will prevent it from being damaged.
Be sure that two or more persons attach the stand.
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect installation of the stand may result in
the TV falling over.
After attaching the stand to the TV, do not hold the stand when you put up, set up,
move or lay down the TV.
Do not remove the stand from the TV unless using a wall mount bracket to mount
it.
1 Confirm that there are 12 screws (eight M6 screws, four M5 screws) supplied
with the stand unit.
2 1 Set the supporting post for the stand unit onto the polystyrene foam.
2 Attach the stand base to the supporting post.
3 Insert and tighten the M6 screws (length: 16mm) into the eight holes on
the bottom of the stand base.
Hold the stand unit securely with one hand, and then tighten the screws.
w For 80/90 inch models
Long
screws
FRONT
1
1
2
3
Stand base
Supporting post
w For 70 inch models
TV front
Supporting post
Stand base
Long screws
3 Insert the stand into the openings on the bottom of the TV (hold the stand so
it will not drop from the edge of the base area).
Make sure that the stand is firmly inserted into the TV. Improper installation may
result in tilting of the TV set.
Instead of using a soft cushion, the cardboard box that the TV is packed in can
be assembled and used as a work table (refer to the instructions on the box to
assemble the work table).
Soft cushion
Preparation