Sharp PG-C20X Projection Television User Manual


 
E-14
Setup & Connections
COMPUTER COMPUTERAUDIO AUDIO
OUTPUT
(INPUT 1)
INPUT 1
RS-232C
Connecting the Projector
Connecting a video source (DTV decoder or DVD player) using the 15-pin input
1 Connect one end of the HD-15/RCA cable or the HD-
15-RGB cable to the COMPUTER INPUT 1 port on the
projector.
2 Connect the other end to the corresponding terminals
on the video source.
3 To use the built-in audio system, connect one end of
the audio cable to AUDIO INPUT 1 terminal on the
projector.
Connect the other end to the audio output terminals on
the video source.
• The projector can only accept 480P DTV signals through
COMPUTER INPUT 1 terminal. Therefore, set your DTV to RGB
monitor output.
The image quality may become lower depending on DTV signal
compatibility.
2 To video output terminals
Projector
Connecting an amplifier and other audio components
1 Connect one end of the audio cable to the AUDIO
OUTPUT terminal for INPUT 1 on the projector.
2 Connect the other end to the corresponding terminals
on the audio components.
CAUTION
Always turn off the projector while connecting to audio
components, in order to protect both the projector and the
components being connected.
• By using external audio components, the volume can be
amplified for better sound.
The AUDIO OUTPUT terminal for INPUT 1 allows you to output
audio to audio components from the AUDIO INPUT 1 terminal
connected to audiovisual equipment.
COMPUTER COMPUTER
O
AUDIO
OUTPUT
(INPUT 1)
INPUT 1
Projector
Amplifier
To audio input terminals
Audio cable (sold separately)
HD-15-RGB cable (sold separately)
Audio cable (sold separately)
3 To audio output terminals
2 To video output terminals
HD-15/RCA cable (sold separately)
DTV decoder
or
DVD player