Sharp PN-ZS701 Home Theater Server User Manual


  Open as PDF
of 2
 
– 4 – – 1 –
Operation Manual
TROLLEY STAND PN-ZS701
Applicable models (as of September 2011) LCD MONITOR PN-L702B
(Available models differ according to region.)
●
Thank you for purchasing a SHARP product.
Before using the product, please be sure to read this operation manual carefully. In particular, be sure to read the section “To
ensure safe and correct use”. After reading the manual, keep it in a convenient location where it can be accessed at any time.
TIPS
- This product was shipped after strict quality control and inspection; however, if breakage or a malfunction should be found,
contact your SHARP dealer or your nearest customer contact.
- Please understand that SHARP CORPORATION bears no responsibility for errors made during use by the customer or a
third party, nor for any other malfunctions or damage to this product arising during use, except where indemnity liability is
recognized under law.
- This product and its accessories may be upgraded without advance notice.
To ensure safe and correct use
This operation manual and the product use various displays and labels to ensure safe use. Ignoring these displays and labels
and incorrectly using the product could have results as classied below.
Please read the following warning symbol information before reading the rest of this section, and be sure to strictly observe all
instructions.
Printed in China
TINSE1212MPZZ(1)
Warning:
Not following these instructions could result
in death or serious injury.
•Theinstallationmustbeperformedbyqualiedservice
personnel.
Improper installation work may cause the monitor to fall or
topple over, resulting in injury.
•Donotplacethestandonanunstablesurface.
Donotsubjecttointenseshockorvibration.
Toppling or falling may occur, causing injury.
•Onlyusethisproductwithspeciedmodels.Donot
modifythestandortheaccessories.
Otherwise, the monitor may fall or the stand may topple
over, resulting in injury.
•Lockthecasterswhenusingthestand.
Toppling may occur, causing injury.
•Donottransportthestandwithamonitorattached.
If the monitor mounting attachments become broken or
damaged, the monitor may fall or the stand may break or
topple, resulting in injury.
•Usethesuppliedscrews.Tightenallscrewsrmly.
Insufcient tightening may cause the monitor to fall or the
stand to topple over, resulting in injury.
Caution:
Not following these instructions could result
in injury or property damage.
•Donotclimbontoorleanonthestandandmonitor.
Toppling may occur, causing injury.
•Ifdeformationorcracksarediscovered,stopusingthe
stand.
Using the stand without repairing the problem may cause
the monitor to fall or the stand to topple, resulting in injury.
•Takesuitablepreventativemeasurestoreducetherisk
ofthisproductfallingortopplingduetoanearthquake
orothercircumstances.
The equipment for preventing falling and toppling will not
be effective if the wall or table to which the equipment is
attached is not sufciently strong. Reinforce the wall or
table sufciently. These measures to prevent falling and
toppling are intended to reduce the risk of injury and other
harm, however, their effectiveness is not guaranteed in all
earthquakes.
Specications
Model PN-ZS701
Height
adjustment
4 positions
Center height of the screen
Approx. 1310 mm (51-9/16 inch) [A],
approx. 1210 mm (47-5/8 inch) [B],
approx. 1110 mm (43-11/16 inch) [C],
approx. 1010 mm (39-3/4 inch) [D]
(Depends on the position of the mounting
brackets attached in Step 1-(4).)
Dimensions See the diagram at right
Weight Approx. 48 kg (105.8 lbs.)
Units: mm (inch)
(Note that the values shown are approximate values.)
899 (35-3/8)
1500 (59-1/16)
1980 (77-15/16)
As a part of our policy of continuous improvement, SHARP
reserves the right to make design and specication changes
for product improvement without prior notice. The
performance specication gures indicated are nominal
values of production units.
There may be some deviations from these values in individual
units.
TIPS
The supplied clamps can be attached to the stand rods and shelf board
bar to hold the cables.
Clamp
Clamp position
Back