Filter
Top Products
41
41
Dimension: 140mm x 215mm
Operation of Remote Control (Continued)
321
654
987
100
0
TV • CATV • VCR • DVD
ABCD
PERSONAL PREFERENCE
9
VCR-CH
8
FLASHBACK
POWER (DVD/VCR)
REC
PLAY
:
L
STOP
FWD
)
REW
(
PAUSE
J
POWER
DISPLAY INPUT
ENTER
;
:
CH
8
VOL
–
VOL
+
9
CH
MENU MUTE
g
SKIP
f
CATV TV
DVD VCR
Note:
L HOW TO IDENTIFY A VCR
The remote control may already be set to
operate your VCR. Try this initial check before
going on to the following “identify” section.
(1) Press
TV/VCR
button.
(2) Point remote towards VCR and press
POWER
(DVD/VCR)
.
(3) Does the remote turn the VCR ON and OFF?
• If yes, the remote is ready to operate the VCR
and no further steps are needed.
• If no, continue to the “identify” section.
L To Identify Your VCR – Direct Entry Method.
Use the following steps and list to quickly find
the remote control code for your accessory
VCR.
• First look up your VCR’s remote control code
number before going through the direct code
entry steps control.
• If this procedure does not identify your
accessory VCR, use the Search method of
identification (described in the next section).
(1) Press
TV/VCR
button.
(2) Press and hold down
DISPLAY
and
on your remote control.
Then release both buttons.
(3) Within ten seconds after releasing
DISPLAY
and , enter your VCR’s two-digit
remote control code number using the
REMOTE KEYPAD
(refer to list).
• The remote control is now ready to send
commands to your VCR.
Some brands have more than one remote code
listed, due to changes in the remote codes from
early to later model years, or due to format
differences (VHS/BETA). In such cases, you
may have to try more than one code to find the
code your VCR accepts.
Depending on the model, year produced, brand,
and type of VCR, some models may not be
compatible with the remote control.
L To Identify Your VCR – Search Method.
(1) Press
TV/VCR
button.
(2) Press POWER on the VCR to ON.
(3) Stand at least six feet away from the front of
the VCR.
Point the remote towards the VCR.
Hold down
DISPLAY
and at the
same time. KEEP HOLDING THE BUTTONS
DOWN.
(4) Watch the Channel Number indicator on the
VCR, Channel numbers will scan up when the
VCR has been identified.
Release
DISPLAY
and as soon as
the channel numbers start to scan up.
The VCR’s remote control code number has
been identified, and the remote is ready to
operate the VCR.
TV POWER
REMOTE
KEYPAD
POWER
(DVD/VCR)
CATV/DVD-TV/VCR
DISPLAY
CHANNEL UP (,)/
DOWN(9)
20F640
CH a
VOL k/l
CH s
CH s
CH a