Filter
Top Products
Note:
Step 1: Wall plate installation
1
3
4
5
6
7
CAUTION:
CAUTION:
Tighten each bolt with a 7/16" socket or open ended wrench by turning clockwise until tight.
Do not release the wall plate until it is properly mounted and secured to the wall.
Position the wall plate against the wall and line up the mounting slots with the drilled holes. Check the bubble
level to verify that the wall plate is level.
For each location, insert bolt (E) and washer (G1) into the wall. Do not tighten until all bolts are in place.
Mark the right (upper and lower) and the left (upper and lower) positions of the small horizontal slots that are in
alignment with the studs. You should mark four positions total.
A) Wood Stud Installation
1. Please ensure that the bubble level (G2) is properly attached to the
wall plate prior to mounting.
Use a high-quality electronic stud finder (commercially available)
to locate two adjacent studs and mark their locations with a pencil
(1-a).
NOTE: For secure wood stud mounting, the wall plate must be mounted to two studs at least
16" apart.
2 Attach the bubble level (G2) to the wall plate and with the help of
an assistant ensure the wall plate is level, position the wall plate
against the wall in the desired mounting location.
Do not over-tighten bolts-doing so many cause unnecessary damage to the wall. Avoid excessive
torque.
2. Please check the two rails before installing, if without the
knob, please install the knob.
Pre-drill a 1/8" hole to a depth of approximately 2" in the wood stud at each marked location.
3