Filter
Top Products
2
3
4
5
6
7
8
9
NOTE: The concrete anchors must be used for concrete installation.
If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall.
Tighten the bolt with the 1/2" socket or 1/2" open-end wrench by turning clockwise until tight.
CAUTION: Do not over-tighten bolts - doing so may cause unnecessary damage to the wall.
CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall.
Next, drill holes using a 1/2" masonry drill bit to a depth of approximately 3".
Insert bolt (I) into each concrete anchor in the wall.
Do not tighten until all bolts are in place.
Insert a concrete anchor into to each hole.
Once all of the anchors are in place, move the wall plate back into position. Check the bubble level to verify that
the wall plate is level.
1 Attach the bubble level (H-2) to the wall plate and with the help of an assistant ensure the wall plate is level,
position the wall plate against the wall in the desired mounting location.
b) Concrete/Brick Installation
Mark four holes to be used for securing the mount and place the wall plate aside.
4