Filter
Top Products
3
Driver Installation
This section provides information on how to install the
USB to RS-422/485 drivers.
Windows 2000/XP/Server 2003
1. Insert the driver CD after Windows boots.
2. AutoRun should start the installation. If AutoRun
doesn’t start, click Start, Run, Type D:\setup.exe,
then click OK. (Change D: to match your CD-ROM
drive letter).
3. Click Next.
4. Click I accept the terms of the license agreement,
click Next, Next.
5. Click Install, Install, then click OK.
6. Click Finish. Restart your system to complete the
installation.
7. Insert the USB to RS-485/422 Converter into a USB
port. The driver will install automatically.
Windows Vista™
1. Insert the driver CD after Windows boots.
2. AutoRun should start the installation.
If Auto Run starts: Click Run setup.exe.
If AutoRun doesn’t start: Click Start, in the Start
Search box, type D:\setup.exe, then press Enter.
(Change D: to match your CD-ROM drive letter).
3. Click allow.
4. Click Next.
5. Click I accept the terms of the license agreement,
click Next, Next.